hughestomm
03-02-00, 01:49 PM
Q. WHAT IF I TURN ON HIGH PRESSURE PUMP AND DIELECTRIC FLUID DOES
NOT COME OUT OF TUBE ELECTRODE?
A. Check the following:
1. Make sure that tube electrode is far enough up
in collet and rubber grommet to allow flow.
2. Try another tube electrode to ensure that debris
has not clogged inside tube.
3. Verify that collet clamping pressure is not
collapsing tube flush hole.
4. Check to see if pump has lost its prime. This
can be done by turning on high pressure pump and
lifting relief valve.
NOT COME OUT OF TUBE ELECTRODE?
A. Check the following:
1. Make sure that tube electrode is far enough up
in collet and rubber grommet to allow flow.
2. Try another tube electrode to ensure that debris
has not clogged inside tube.
3. Verify that collet clamping pressure is not
collapsing tube flush hole.
4. Check to see if pump has lost its prime. This
can be done by turning on high pressure pump and
lifting relief valve.